SAMSUNG DCS PROGRAMMING
TECHNICAL MANUAL December 1996
MMC: 733 AA PLAN TABLE
DESCRIPTION:
This MMC will be used to build AA PLAN TABLE which consists of main factors, i.e.
system prompt messages, decide to the next call flow according to the status of dialed party
and assigning dialed digit translation table.
It will be assigned to a specific AA port or a group of AA ports through MMC 735.
There are totally 64 messages on a AA board;
- 48 messages are to be recorded by the user (01-48),
- 16 messages are pre-recorded in ROM on the board (49-64).
It’s attributes are as follows;
ATTR TITLE DATA COMSG
0 DAY MSG 01-64 Introduction Message during Day Mode
1 NIGHT MSG 01-64 Introduction Message during Night Mode
2 ALTER MSG 01-64 Emergency Message
3 INVLID MSG 01-64 Message when dialed invalid
4 NO ANS MSG 01-64 Message on no answer reply
5 XFER MSG 01-64 Transfer notifying Message
6 BUSY MSG 01-64 Message on busy reply
7 NO STN MSG 01-64 Message on retrial
8 NO ACT MSG 01-64 Message on no action
8 CAMP Yes/No Allow Camp-on onto busy extension
9 ANS DELAY 01-10 Delaying until answer (sec)
10 RETRY CNT 0-5 Count for allowing retry on faulty
11 TRANS TABLE 01-12Assigning associated TRANS TABLE
12 BUSY DEST DEST Alternative destination on busy
13 NO ANS DEST DEST Alternative destination on no answer
14 NO ACT DEST DEST Default destination on no action
15 INVALID DEST DEST Default destination on invalid action
There are totally 12 tables (01-12) maximum in the system and not necessary to be
programmed all tables.
DESTINATION : STATION,STATION GROUP,AA PLAN NO, REPEAT.
ACTION DISPLAY
1. Press TRSF 733
Display shows
AA PLAN PROG(01)
DAY MSG : NONE
2. Dial AA PLAN TABLE number
OR Press UP or DOWN
press RIGHT soft key
[AA PLAN PROG(02)
DAY MSG : NONE
3. Dial attributes number
OR Press UP or DOWN
press RIGHT soft key
AA PLAN PROG(02)
NIGHT MSG :NONE
