SAMSUNG DCS PROGRAMMING
TECHNICAL MANUAL December 1996
MMC: 722 STATION KEY PROGRAMMING
DESCRIPTION:
Allows for the customizing of programmable keys on specific electronic keysets on the DCS
system. Buttons 1 and 2 are set as CALL buttons by default. Features are entered via the dial pad
key by pressing the dial pad number the required steps to select the feature. For example, for
OHVA the number 6 is pressed three times. If the BOSS key is required, press 2 for the first letter
B, and then use the UP or DOWN key to change selection from BARGE to BOSS.
DIAL KEYPAD
COUNT®
1 2 3
DIAL 2 AAPLAY BARGE CALL
DIAL 3 DICT DICT FAUTO
DIAL 4 GPIK HLDPK IOG
DIAL 5 LCR LCR LCR
DIAL 6 MMPA NEW OHVA
DIAL 7 PAGE REJECT SG
DIAL 8 TG UA VDIAL
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPK Used to store data and advance to next MMC
HOLD Used to clear previous entry
ACTION DISPLAY
1. Press TRSF 722
Display shows
[201] KEY PROG.
01:CALL1 →
2. Enter selected station number (e.g., 205)
OR
Press UP or DOWN key to select station number and
press RIGHT soft key to move cursor
[205] KEY PROG.
01:CALL1 →
3. Enter selected key number (e.g., 18)
OR
Press UP or DOWN key to select key number
and press RIGHT soft key to move cursor
[201] KEY PROG.
18:NONE →_
4. Using above chart pressing dial pad key
number to make selection
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to advance cursor to step 5 to enter
extender if required or to return to step 2
[201] KEY PROG.
18:NONE →GPIK_
