
DKT/IPT Settings
IPT Setup Instructions
Strata CIX and CTX Telephones Administrator 12/04 17
IPT Setup Instructions
1. Press ++++ROG (simultaneously).
2. Press
, then press +ROGto select the Network Setting Mode.
3. Press
)% to see if the DHCP server is in use or not. Press one of the following
(normally, use
: manual setting):
: manual setting, then press +ROG.
: auto setting by DHCP server, then press +ROG.
4. Press
)%. Enter the IP address for this IPT and press +ROG. To enter the period in
an IP address, press the
button on your dialpad (e.g., if the IP address is
“192.168.1.241,” press
).
5. Press
)%. Enter the subnet mask number and press +ROG. (e.g., if the subnet
mask address is “255.255.255.0, press
).
6. If the IPT is connected to a router or other gateway device, press
)%. Enter the
router address, then press
+ROG. Only used if Step 3, above, is set for manual
setting.
7. Press
)%. Enter a Station ID for the IPT and press +ROG. This is usually your
telephone’s primary number (PDN).
8. Press
)% to enter the CTX Strata Net node number of the CTX node that contains
the BIPU-M3A to which this IPT interfaces, then press
+ROG. This FB setting is
for CTX networked systems only.
9. Press
)% for BIPU IP address mode. Press one of the following:
: manual setting, then press +ROG. Press )% and enter the BIPU IP address,
then press
+ROG. (e.g., if the BIPU IP address is “192.168.1.241,” enter it in this
format
).
: auto setting by broadcast, then press +ROG.
: auto setting by multicast (IPT doesn’t support multicast setting in this first
release), then press
+ROG.
10. Press
+ROG again to set all the above data.
11. Go off-hook and hang up. The IPT will search for the BIPU-M1A, initialize and
then set the IP address (from 20 sec. to 60 sec.). Time, Date and PDN displays on
LCD when the information is set.
Note See “IP Telephone Start Up Sequence” below for an explanation of the LCDs
that you will see during this procedure.