LS7000 LEVEL SWITCH
1. DESCRIPTION
A. General Description
The LS7000 is a point level switch that detects the presence or absence of material in a bin, silo, tank or other
container. The basic unit is made up of a solid stainless steel probe attached to an explosion proof housing.
Inside the explosion proof housing are all calibration adjustments and sensing electronics. The unit is calibrated
in the absence of material and an internal relay changes state when material is detected.
B. Specifications
Electrical
Power: 115 VAC (±15%) 50/60 Hz. 2 watts, standard.
(12 VDC, 24 VDC or 230 VAC optional)
Output 2 Form C contacts, DPDT relay, 5 amp resistive
At 125, 250 VAC; 30 VDC
Fuse: On board, 250 mA @ 125 volts
Fail Safe: Selectable high or low level
Time Delay: Selectable: ON or OFF delay
Adjustable: 1/8 sec to 2 hrs.
RF Frequency: Approximately 1.3 MHz
Environmental
Hazardous Area: Class I, Group D, Class II, Group E, F, G
Temperature: Probe: -30° F to 400° F
Electronics: -40° F to 185° F
Pressure: Probe: 1500 psi @ 75° F. Higher ranges available
on request.
Construction: Probe: All wetted parts, 316 SS Teflon and Viton.
A Halar coating can be applied to the probe when
applicable.
Electronics: Housed in cast aluminum explosion
proof enclosure.
Specifications subject to change without notice.
C. Ordering Information
1
LS7000 – 115VAC – S – 10*
Model
Supply Voltage
“S” – 316 Stainless Steel Probe
“H” – Halar Coated Probe
Probe length in inches
*This describes an LS7000, powered by a 115 VAC,
with a 316 SS probe, 10” long. The probe length is
measured from the end of the nipple to the tip of the
probe
.
1” NPT
1” NPT
½” DIA. 316 SS
6 1/8” 5 1/8”
INSULATOR
1 7/8”
4 ¾” 4”
MAX
10” Standard
Longer Lengths Available
FIGURE 7.1
