PT300, Service Manual
Rev B, October, 2000
1
SAFETY SUMMARY
The following general safety precautions must be observed during all phases of
operation, service, and repair of this scale. Failure to comply with these precautions or
with specific warnings elsewhere in this manual violates safety standards of design,
manufacture, and intended use of the scale. Intercomp assumes no liability for the
customer's failure to comply with these requirements.
DO NOT OPERATE IN AN EXPLOSIVE ATMOSPHERE.
Do not operate the scale in the presence of flammable gases or fumes. Operation of
any electrical instrument in such an environment constitutes a definite safety hazard.
DO NOT SUBSTITUTE PARTS OR MODIFY SCALE.
Because of the danger of introducing hazards, do not substitute parts or perform any
unauthorized modifications of the scale.
NOTICE
All rights reserved. The information contained in this publication is derived in part from proprietary and
patent data of the Intercomp corporation. This information has been prepared for the express purpose of
assisting operating maintenance personnel in the efficient use of the instrument described herein.
Publication of this information does not convey any rights to use or reproduce it or to use it for any
purpose other then in connection with the installation, operation, and maintenance of the equipment
described herein. While every precaution has been taken in the preparation of this manual, Intercomp
Corporation assumes no responsibility for damages resulting from the use of the information contained
herein. All instructions and diagrams have been checked for accuracy and ease of application; however,
success and safety in working with tools depend largely upon the individual accuracy, skill, and caution.
For this reason Intercomp Company is not able to guarantee the result of any procedure contained
herein. Nor can they assume responsibility for any damage to property or injury to persons occasioned
from the procedures. Persons engaging the procedures do so entirely at their own risk.
COMPLIANCE WITH FCC RULES
Please note that this equipment generates, uses, and can radiate radio frequency energy. If this
equipment is not installed and used in accordance with the support manual, you are warned that it may
cause interference to radio communications. This unit has been tested and has been found to comply
with the limits for a Class A computing device pursuant to subpart J of part 15 of FCC Rules. These
rules are designed to provide reasonable protection against interference when equipment is operated in a
commercial environment. However, if this unit is operated in a residential area, it is likely to cause
interference and under these circumstances the user will be required to take whatever measures are
necessary to eliminate the interference at his own expense.
