Dishwasher
Fully-Integrated, Integrated, Substructure, Upright Dishwashers with Flow-Type Heaters and
Easytronic Plus
Specifications
- 19 -
TSE-N 03.00 A. B. 599 50 69-23 EN
Measuring points at the electronic control (in the base)
3-pol. Stecker
123
1273465
273465
1
2345
1
14
23
1
14
1414
KL5 M2.1 S5 V2.1 V2.2 R2 M2.2 Q2 N2 T2 E5
NTC temperature sensor
temperature/resistance 20 °C
6032
25 °C
4829
(only w ith fully electronic 30 °C
3891
dishw ashers) 40 °C / 2573
Ω
50 °C / 1741
Ω
55 °C / 1444
Ω
60 °C / 1204
Ω
65 °C / 1009
Ω
70 °C/849
Ω
7-pole connector
3-pole
connector
4-pole
connector
to the input
module
to the input
module
4-pole
connector
4-pole
connector
Measure all resistances with
plugged-off connector.
turbidity sensor
1 - 2 6 - 11,4 V
1 - 3 clear water 4,3 V
turbid water in prewash < 3 V
turbid water in intermediate rinsing < 3,8 V
3-pol. Stecker
Front side of board
3-pole connector
filling solenoid s11 4 kW
regenerating solenoid s9 3kW
heating contactor c2 6,7 kW
rotary slide drive 1 - 3 9 kW
positioning contact 1 - 2
upper sprayarm ¥W, lower sprayarm 0W
tachymetric generator g1
213 W
thermal sensor NTC
pressure switch fN with level 0 W
reed switch salt b92 with missing salt 0 W
7-pole connector Pin Widerstand
Attention!
With the 7-pole connector clamps 7 and 5
have the mains voltage. When measuring
the resistance the mains plug must be
absolutely unplugged or the fuse turned
off.
circulation pump main winding m8 1 - 2
59
Ω
drain pump m3 normal 5 - 6
170
Ω
drain pump m3 float switch f 16.1 or safety
pressure switch fS has reacted
5 - 7
170
Ω
