2
Electrical Connections
Be sure to check the data plate, located on the liner of the cabinet, for required voltage prior to connecting the unit to a power
source. The specifications on the data plate supersede any future discussion.
The standard unit is equipped with an eight (8) foot power cord that requires a 115 Volt, 60 Cycle, 1 Phase properly grounded
electrical receptacle. The power cord comes with a 3 pron
g plug for grounding purposes. Any attempt to cut off the grounding
spike or to connect to an ungrounded adapter plug will void the warranty, terminate the manufacturers responsibility and could result
in serious injury.
The circuit must be protected wit
h a 15 or 20 ampere fuse or breaker. The unit must be isolated on a circuit and not plugged into an
extension cord.
OPERATION
Initial Start Up:
After satisfying the installation requirements, the unit is ready to start. The unit will start when the powe
r cord is connected to the
required power source. If the compressor does not start when the unit is initially plugged in, check to make sure that the
temperature control is not in the ‘off ‘ position. Allow the unit to run a minimum of two hours before loading it with product.
Temperature Control
The Temperature Control is located on the back wall of the cabinet liner and is factory set to maintain an average cabinet
temperature of 35 to 40 Deg. F.. To access the temperature control, remove the top dra
wer from the cabinet, (top right drawer on
model SKRCB79). To obtain colder temperatures turn the Temperature Control stem clockwise and visa versa. Allow the unit a
minimum of one hour to respond to a control setting adjustment.
Defrost
Your Silver Kin
g unit is an automatic defrost unit. No additional plumbing is required. Defrost water is collected in a pan located in
the compressor compartment where it is evaporated into the room air. It is important that the unit be level so the condensate can
drain properly.
MAINTENANCE
Preventative maintenance is minimal although these few steps are very important to continued operation and maximizing the life of
the appliance.
Cabinet Surfaces
The cabinet interior and exterior are stainless steel. These surfa
ces should be cleaned periodically with a solution of warm water
and mild soap. After cleaning the surfaces should be rinsed with clean water and wiped dry with a soft cloth. Stainless steel
cleaners can also be used. Should a surface become stained, do
not attempt to clean with an abrasive cleaner or scouring pad.
Use a soft cleanser and rub with the grain of the metal to avoid scratching the surface. Always rinse well and dry after cleaning.
Do not use chlorinated cleaners.
Condenser
Periodically,
dust on the condenser coil must be cleaned. The condenser is located behind the front cover at the right front of the
unit. Remove the front cover by removing the two (2) screws at the left side of the cover and swinging the cover off the cabinet.
The
condenser will be exposed. Clean the accumulated dust/debris from the condenser with a vacuum or brush. This will need to
be done regularly to maintain the compressor warranty!
Drawer Wheels
Lubricate the drawer whells periodically to obtain maximum life from the wheels.
Casters
Check to make sure that the casters are installed tightly to the cabinet.
MODEL SERIAL NO. DATE INSTALLED
