68
Before the 1st washing
The washing machine was inspected thoroughly before leaving
the factory. To remove any water left over from testing
procedures, the first washing cycle should be carried out without
laundry in the machine.
²
The washing machine must have been installed and connected
properly. See chapter Installing ~ Page 65
1.
Check the machine.
²
Never switch on a damaged machine. Inform your customer
service. ~ Page 52
2.
Fill dispensers ô / M ô . ~ Page 34
3.
Remove protective film from the fascia.
4.
Insert mains plug.
5.
Turn the tap on.
6.
Switch on the appliance.
7.
Close the washing machine door. Do not load any washing.
8.
To prevent unused detergent from flowing into the outlet
during the first wash: Pour 1 litre of water into dispenser
ÀÁ
and start the Drain programme.
9.
Select and start the Cotton 90 °C programme.
10.
When the programme ends, switch off the appliance.
Your washing machine is now ready for use.
Page 34
www.devicemanuals.eu
Page 34
Remove protective film from the fascia.
www.devicemanuals.eu
Remove protective film from the fascia.
Close the washing machine door. Do not load any washing.
www.devicemanuals.eu
Close the washing machine door. Do not load any washing.
To prevent unused detergent from flowing into the outlet
www.devicemanuals.eu
To prevent unused detergent from flowing into the outlet
during the first wash: Pour 1 litre of water into dispenser
www.devicemanuals.eu
during the first wash: Pour 1 litre of water into dispenser
Drain
www.devicemanuals.eu
Drain
programme.
www.devicemanuals.eu
programme.
Select and start the
www.devicemanuals.eu
Select and start the
When the programme ends, switch off the appliance.
www.devicemanuals.eu
When the programme ends, switch off the appliance.
Your washing machine is now ready for use.
www.devicemanuals.eu
Your washing machine is now ready for use.
