Setting the water softener manually (see table)
Set switch to position 1 or
2
The water softener is factory set at position 2.
Setting the water softener
electronically (see table)
1. Press the On/Off button. The appliance
must be in setting mode.
2. Press and hold Programme selection/
Cancel button until programme light A
flashes and programme light B illuminates
with fixed light.
3. After a few seconds:
–
programme light B turns off
–
programme light A goes on flashing
–
End of programme light starts flashing:
the number of flashes corresponds to
current level set. The flashing is repea-
ted with a pause of a few seconds.
Examples: 5 flashes, pause, 5 flashes,
pause, etc... = level 5.
4.
To change the level, press the Programme
selection/Cancel button. Each time the
button is pressed the level increases (level
1 follows level 10). The End of pro-
gramme light indicates the new setting.
5. To memorise the operation, switch off the
dishwasher.
Use of dishwasher salt
CAUTION!
Use only special salt suitable for dishwashers.
10
