25
Water outlet hose connection
The end of the drain hose can be connected in the
following ways:
1. To the sink outlet siphon, securing it if necessary with a
clip.
2. Hooked over the edge of the sink using the special
curved plastic guide (if provided).
3. To a stand pipe provided with vent-hole, minimum
internal diameter 4 cm.
The waste connection must be at a height of between 30
cm (minimum) and 100 cm (maximum) from the bottom of
the dishwasher.
The drain hose can face either to the right or left of the
dishwasher
Ensure the hose is not bent or squashed as this could
prevent or slow down the discharge of water.
If you use a drain hose extension it must be no longer
than 2 metres and its internal diameter must be no smaller
than the diameter of the hose provided.
Likewise the internal diameter of the couplings used for
connections to the waste outlet must be no smaller than
the diameter of the hose provided.
Electrical connection
Before plugging the appliance into the wall socket, make
sure that:
1. The mains voltage corresponds to the voltage given in
the "Technical specifications".
2. The meter, fuses, mains power supply and wall socket
can all take the maximum load required.
Make sure that the socket and plug are compatible
without having to use any type of adaptor. If necessary,
have the domestic wiring system socket replaced.
Safety standards require the appliance to be
earthed.
The manufacture accepts no liability for failure
to observe the above safety precautions.
This appliance complies with the following E.E.C. Directives:
- 73/23 of 19.2.73 (Low Voltage Directive) and subsequent modifications;
- 89/336 of 3.5.89 (Electromagnetic Compatibility Directive) and subsequent modifications.
Attention!
Our appliances are supplied with a security
device to protect against the return of dirty
water back into the machine.
If the siphon of your sink has a "no return
valve" incorporated this can prevent the
correct draining of your dishwasher.
We advise you therefore to remove it.
