Dil ID: 11
Dil Adı: russia
Dil Kodu: ru1tayfun Продукция бренда Whirlpool
Dünyanın En Büyük
Elektronik Bilgi Kütüphanesi



USING YOUR DISHWASHER
For models with more than three buttons:
Push a Cycle Selector button for the desired
cycle. Use any Cycle Selector button with the
Rinse & Hold cycle. The Cycle Control knob
determines which cycle operates.
3. Turn the Cycle Control krK>b clockwise to point
to the desired cycle. See page 8 for cycle
descriptions.
You will feel a definite stop at each cycle mark.
The dishwasher will automatically start the cycle
you selected.
NOTE: If the door is latched, you will hear
cycles start and stop as the knob passes each
cycle mark. This is normal and will not hurt the
dishwasher. If you prefer, you can set cycles
with the door unlatched.
Cycles may vary with models
Cycles may vary with models
Adding a dish during a cycle
(model series WU3000 and WU4000, WU5750)
You can add an additional item to the dishwasher anytime before the Cycle Control knob
reaches LIGHT WASH. See page 8.
1. Lift up on the door latch to unlatch the
door and stop the cycle. Wait a moment
for the spray action to stop before open
ing the door.
2. Open the door and add the dish.
3. Close the door. Do not latch It.
Wait 30 seconds for air in the dishwasher
to warm up. This helps reduce the
amount of moisture that can come from
the vent when restarting the cycle.
Press door in to latch it. The dishwasher
will start where it stopped.
Changing a cycle setting
(model series WU3000 and WU4000, WU5750)
You can change a setting anytime during any cycle
1. Lift up on the door latch to unlatch the
door and stop the cycle.
2. Turn the Cycle Control knob clockwise to
the cycle you want.
3. Check the detergent dispenser to be sure
it is properly filled for the new cycle. See
page 10. 4.
NOTE: Turning the Cycle Control knob
may cause the covered section of the
detergent dispenser to open. Be sure to
fill the covered section, and close the
cover, if the cycle uses detergent in
both sections.
Cbse and latch the door. The dishwasher
will automatically start the new cycle.
Canceling a cycle
You can cancel a cycle anytime during the cycle.
1. Turn the Cycle Control knob slowly
clockwise to the drain portion of the wash
or rinse. You will hear water draining
when you have advanced to the proper
location.
2. Let the dishwasher drain completely.
3. Lift up on the door latch to unlatch the
door.
4. Turn the Cycle Control knob clockwise to
point to OFF. 7