16
ARISTON DISHWASHER - Instructions for installation and use
D
ISHWASHER
The delayed start is
also reset
automatically should
you fail to select the
wash cycle within 15
seconds.
Duo Wash
Cycle:
This is a special cycle that runs
a differentiated wash on the
two racks: delicate for
glassware and glasses on the
upper rack and heavy duty for
saucepans and frying pans on
the lower rack.
Press the (Mode) button
and select the Duo-Wash
symbol, then press (Select):
on means it is selected and
the corresponding rectangle
will light up, whereas off
means it is disabled; after
approx. 5 seconds, you will
automatically quit the menu.
Now press Start and the wash
cycle starts with a beep.
You decide when
it starts.
When you have loaded the
dishes, you can choose when
to start your dishwasher before
setting the wash cycle desired.
Press button M (Mode) and
then select the symbol
corresponding to the delayed
start:
the corresponding rectangle
will darken. Now press button
S (Select) to delay the wash
cycle start by 1 to 24 hours. If
you press the button again, the
word OFF is displayed (no
selection made).
Once you have made your
selection, make sure the
appliance door is shut and start
the wash cycle by pressing
button START
.
The countdown to the delayed
start will begin on the display.
Once the countdown is up, the
wash cycle begins and the
approximate amount of time
left until the end of the wash
cycle is displayed.
Have you changed your
mind?
If you change your mind and
wish to set a different delay
press the Mode and Select
buttons and repeat the
selection.
If on the other hand you want
to cancel the delay set and you
wish to start the wash cycle
immediately, press the Select
button repeatedly until it is set
to zero.
The following indicator light
will turn off:
Do you want extra
drying?
Before you start the selected
wash cycle, press button M
(Mode) repeatedly until the
extra drying symbol G is
selected, and the
corresponding rectangle lights
up. Press button S (Select)
and select On to enable the
extra drying, or Off to disable
it. Remember that with the
extra drying enabled, the wash
cycle will last longer to provide
you with dryer dishes.
This option is incompatible
with the soak cycle.
You want to wash
just half
a load?
Remember to halve the
amount of detergent.
Have you only got a few dishes
that need washing? If so, load
them all on a single rack to save
on water, detergent and
electricity. Press the Mode
button repeatedly until symbol
N is selected: the
corresponding rectangle will
light up. Using button S (select),
you can decide to wash a half-
load on the upper rack
or on the lower one .
Each time you press it, a beep
will sound and the
corresponding symbol will light
up. The symbol for the selected
rack is displayed. Off means no
selection has been made
Once you have made your
selection, start the wash cycle
by pressing START.
This option is available with
all wash cycles.
