17
Upper spray arm:
1.
Remove upper rack.
2.
Slacken the fixing nut (by turning it counterclockwise) and
detach the spray arm by pulling it down.
3.
Rinse the nozzles.
4.
To remount the spray arm, align it and then tighten the fixing nut
(by turning it clockwise)
,
paying attention not to bend it.
The
fixing nut must be tightened until it clicks!
Make sure the spray arm rotates freely.
Lower spray arm:
1.
Remove lower rack.
2.
Detach the spray arm by pulling it up while stretching the latches.
3.
Rinse the nozzles.
4.
To remount the spray arm, align it paying attention not to bend it.
Push the spray arm down until “click” is heard.
Make sure the spray arm rotates freely.
Cleaning the filters
1.
Rotate the coarse filter counterclockwise (in the direction of the
arrow) and extract it.
2.
Remove the microfilter from the coarse filter by releasing the
latches.
3.
Remove the microfilter by pulling it.
4.
Clean all filters under running water,
paying attention not to bend
the fine-mesh coarse filter. Check that no impurities are left
inside the dishwasher!
Remounting:
Insert the microfilter in the coarse filter (
F
).
Insert the fine-mesh filter.
Ensure that the marks are aligned.
Insert the microfilter filter (
G
) in the Main filter unit (
H
) and
turn clockwise to lock.
The filter unit must be correctly assembled to ensure good
wash results!
G
F
H
3gb94300.fm Page 17 Thursday, April 4, 2002 3:54 PM
Black process 45.0° 100.0 LPI
