- 8 -
5. Pins 1-4: Inputs from Amplifier outputs - connect to
the power amplifier speaker outputs corresponding to
Ls, Rs, Bsl & Bsr.
Pins 5-8: Crossover outputs - connect to the power
amplifier inputs corresponding to Bsl+, Bsl-, Bsr+, Bsr-
channels, Ground and Line Out. Note: Line Out level
is affected by Amplifier level (4) and Processor level
(22)
6. HD-15 connector - connect to SW amplifier.
7. HD-15 connector - connect to Bsl/Bsr amplifier.
8. HD-15 connector - connect to Ls/Rs amplifier.
9. Crossover outputs - connect to the power amplifier
inputs corresponding to Rch+, Rch-, Rcm+, Rcm-,
Rcl+, Rcl- Ls+, Ls-, Rs+, Rs-, SW+ & SW- channels.
10. HD-15 connector - connect to Rcl amplifer
11. HD-15 connector - connect to Rcm*/h amplifier.
12. HD-15 connector - connect to Lc amplifier.
13. HD-15 connector - connect to Lcm*/h amplifier.
14. Crossover outputs - connect to the power amplifier
inputs corresponding to Rh+, Rh-, Rm+, Rm-,Rl+, Rl,
Lch+, Lch-, Lcm+, Lcm-, Lcl+ & Lcl- channels.
21. HD-15 connector - connect to Lm*/h amplifier.
22. Processor level - this trimpot adjusts the sensitivity
of the front panel Bargraph meter and Line Out when in
Processor mode.
23. Bargraph level - this trimpot adjusts the sensitivity
of the front panel VU Bargraph.
24. Main input - connect this to the main outputs of the
processor.
25. AC Emergency power input - 12-16VAC, 0.5A
26. Channel configuration DIP switches. See page 15.
27. Optional input - connect these to the EX outputs of
the processor.
* - When used in Biamp mode, Mid band becomes
the Low band output
