
O/:
eratino :-i Cable Box or DFi Receiver
Setting the Manufacturer's
Code
You can program the supplied remote
control to operate a cable box or DBS
receiver.
Press CODE SET, DBS/CABLE
(FUNCTION), the 0-9 buttons to enter the
manufacturer's code number (see the
following chart), then press ENTER.
For example, to operate a Sony DBS receiver:
^ ENTER
+ (§) + (q) + ri) +
Manufacturer code numbers
(DBS receiver)
FUNCTION
CODE SET OeS/CABL£
+
Manufacturer code numbers
(cable box)
Manufacturer
Gemini
Hamlin/Regal
Jerrold/G. I.
Macom
Magnavox
Oak
Panasonic
Philips
Pioneer
Samsung
Scientific Atlanta
Tocom
Zenith
233
222, 223, 224, 225, 226
201, 202, 203, 204, 205,
222, 206, 207, 208, 218
230, 231, 232
234
227, 228, 229
219, 220, 221
236, 237, 238, 239, 240, 241
214, 215
235
209, 210, 211
216, 217
212, 213
Manufacturer
Code number
Sony
801 (preset code for
remote control)
General Electric
802
RCA/PROSCAN
802
Code
To operate the projection TV
Press TV (FUNCTION). Then use the
projection TV control buttons to control the
projection TV.
For more details on operating the
cable box or DBS receiver
Refer to the operating instructions that come
with the equipment.
If the remote control doesn't work
• Try repeating the set up procedures using
the other codes listed for your equipment.
• If moil’ Ihiw one code mwiber is listed, try e]iteriuc>
llieni one by one until yon come to the correct code for
your equipment.
• If you enter a new code number, the code number you
I’reviously entered at that setting is erased.
• In some rare cases, you may not be able to operate
your equipment with the supplied remote control. In
this case, use the equipment's own remote control
unit.
• Whenever you remove the batteries — to replace
them, for e.xample — if too much time is taken, the
code numbers may revert to the factory settiuy and
must be reset.
//;>> V
54