Connecting two VCRs for tape
editing
SELECT OUT gives you the ability to use a
second VCR to record a program being
played by the primary VCR or to perform
tape editing and dubbing.
1 Connect the VCR intended for playback
using the connection instructions on
pages 6 and 7 of this manual,
2 Using AUDIO/VIDEO connectors,
connect AUDIO and VIDEO IN on your
VCR intended for recording to SELECT
OUT AUDIO and VIDEO on your
projection TV.
Notes:
• Do not change the input signal while
editing through SELECT OUT.
• When connecting a single VCR to the
projection TV: if VCR LINE OUT is
connected to projection TV's VIDEO IN,
do not connect the projection TV's
SELECT OUT jacks to the VCR LINE
INPUT (see right). Doing so will cause
program interference and other viewing
problems.
• You can select the output signal from
SELECT OUT from the SET UP menu, (see
"SELECT OUT" on page 48)
Disconnect all power sources before making any connections.
(Rear of piojettion TV)
VMC-810S/820S (not supplied)
(Rear of projectionTV)
VMC-810S/820S (not supplied)
Indicates direction
of signal
13
