On Screen Displays (OSD)
Channel & Function Display
Whenever the channel is
changed, the Channel
number will appear for a few
seconds on-screen.
(Some station names may
also appear.)
When a function button is
pushed (PLAY, FF, etc.)
the Combination VCR
mode will be displayed.
• When a recording is started, both REC and
the channel will appear together.
Menu Screen
1 Push the MENU button to
display the menu.
2 Push the SELECT Up/Down
and SET buttons to make
your selection.
E]
n
CLOCK EXIT
SELECT
SET
PUSH SELECT A/T
PUSH SET KEY
Warning and Instruction Displays
These will alert you to a nnissed operation or provide
further instructions.
If no active channels are
found for CHANNEL
MEMORY...
if a Timer Program was not
completed before exiting the
Program mode...
If you push the REC button
on the remote control or the
REC and PLAY buttons on
the Combination VCR, and a
cassette is inserted with no
record tab...
NO CH FOUND
PLEASE CHECK ANTENNA
CABLE CONNECTION THEN
PUSH CH UP KEY AGAIN
PROGRAM IS INCOMPLETE
CHECK CASSETTE
RECORD TAB
To get the most from each feature, it is
recommended that you read the Operation
Manual before attempting any operation.
VCR Status & Clock Display
Push the DISPLAY button to display and remove
the overlay shown below.
Rec Time
Remaining
(OTR mode only
see page 15.)
Tape
Counter
Function Status
L
Time
Channel &
Call Letter
Tape Speed
If you push the STOP button
during a Timer Recording...
TO CANCEL TIMER REC
HOLD DOWN STOP KEY
FOR APPROX 3 SEC
If you push the PLAY, FF,
REW, or REC button on the
remote control or if you push
the REC and PLAY buttons,
the FF, PLAY, or REW button
on the Combination VCR
without a cassette inserted...
If you attempt to set or review
a Timer Recording or set the
On Timer and the Clock is
not set...
NO CASSETTE
PLEASE INSERT A CASSETTE
PLEASE SET CLOCK
BEFORE PROGRAMMING
Blank Tape and will be Blue Screen
If a blank section of tape is encountered in the Play
mode or the channel you select has no broadcast,
the TV screen will change to a solid blue field.
The screen will remain blue until a recorded signal
is again detected or an active channel is selected.
Two minutes before a Timer
Recording is about to begin...
PLEASE PREPARE
FOR TIMER REC
8
