Timer Recording
Your Combination VCR can be set up to
do a recording while you are away or
otherwise occupied. Up to 8 programs can
be placed in memory. You can choose to
record one time, daily, or weekly.
^^heck list before you begin.
D All connections are made. (See page 5.)
13
Your Combination VCR is plugged in.
I] The clock is set.
D The tape is long enough.
^ The record tab is in place.
indicator
(D
PROG
Push PROG to display
the program screen.
• If a program is already in
memory, push the SELECT
Up/Down and SET buttons to
select an unused program
number.
START STOP ch]
SLPI
SELECT START DATE
BY SELECT A/T KEY
:PUSH SET
TO END PUSH PROG KEY
SEL
and
SET
O
Push SELECT UP/
DOWN and SET, to
select and enter the
DATE.
Today's Date
^WEEKLlf{SAT)<—7-f8-9--31^
Wheel SelecLn Order |
^WEEKLY(SUN)
---
DAILY— 6—^
Daily and Weekly Timer Recording
If you want the program to be recorded daily
(Mon thru Fri), enter DAILY in place of the
DATE in step 2. If you want the recording to
be on a weekly basis, enter WEEKLY MON,
TUE, etc..
[}ATf / START
J
^nIfV
BY SE
iUNi I ''
BY SELECT i/T KEY
‘P
SEL
"O
and
SET
O
Push SELECT UP/
DOWN and SET to
select and set
remaining items at
right.
Remaining Items to be set:
• START time
• STOP time
• CH(annel) number,
or LINE for outside
source recording.
• Speed (SP. LP, SLP).
To Make Corrections
Repeatedly push the SET button to move forward, or the CLEAR button to
move back to the desired item.
PROG
O
Push PROG to end
the program.
• If you want to enter more
programs, select a blank program
number with the SELECT Up/
Down and SET buttons, and then
repeat steps 2 and 3.
P DT STRAT STOP CH SPD
2 —
3 —
4 —
SELECT 1-8:PUSH A/T KEY
ENTER :PUSH SET KEY
CANCEL :PUSH CLEAR KEY
END :PUSH PROG KEY
PROG
o
Push PROG to exit
this mode.
• The PROGRAM TIMER indicator
lights on the front panel.
• If you’re using a cable box, make sure that it is turned to the
desired channel and the power is left on for timer recording.
Two minutes before the Timer Recording starts, ‘TIMER REC WILL START
SOON” will appear on-screen.
If “PLEASE PREPARE FOR TIMER REC" appears and/or the PROGRAM TIMER indicator flashes, check that a
cassette with record tab is loaded and the Combination VCR is in Stop mode.
If the start times of two programs overlap, the lower numbered program will have priority.
If the start time for a timer recording comes up during a normal recording or One Touch Recording (page 15),
the timer recording will not be performed.
If there is a power interruption of more than one minute, the recording may not be performed or continue.
If “PROGRAM IS INCOMPLETE" appears on-screen in step 4, check all entries and make necessary corrections
16
