V
General Operation
8
(TV set)
How to switch the power ON or OFF
The TV set must first be switched on at the
wall outlet and at the Power Switch (refer to
page 7).
Press this button to turn the TV set ON, from
STANDBY mode.
Press it again to turn the TV set OFF,
STANDBY mode.
Note;
• Mainly the remote control for TX-29P250X, TX-
68P250Z, TX-80P250Z is used as an example in
the Operating Instructions.
• The TEXT Operation buttons not present for Models
not equipped with certain features.
The diagram on page 6 identify such variations.
-Power-Ingicater
STANDBY-RED
Power ON “ No light up
Note;
• It is also possible to turn the TV set on
STANDBY by pressing the “Direct
Programme Number Selection" Buttons (0-
9) and the "Programme Number Up or
Dovm” Button, either on the set or on the
Remote Control.
Programme Number Selection
Press the Programme Number Up “a" or
Down "v" Button to select the next higher or
lower Programme number.
Direct Programme Number Selection
(CH SELECT = POSITION)
You can select the numbers directly by
pressing "Number 0-9" button and the two
digit Numbers by pressing "Two Digit” and
"Programme Number” buttons.
Programme Number 8
..........
^
Programme Number 12
...........
^ B ’ B
Direct Programme Number Selection
(CH SELECT = DIRECT)
You can select the number directly by
pressing the corresponding programme
nurnber button.
Programme Number 8
........
Q
Programme Number 36
....
^ ^
Programme Number 124... ^ B ®
Note:
• When the Skip setting for Programme
Number 100 through 125 is on, the channel
selection time wilt be shortened, and thus
you can not input three digits at a time.
14
