─ 6 ─
■ Over-discharge prevention
function
• When using the lantern with the
LAMP/LED selector in the “LAMP”
position (i.e., when using as a
fluorescent lamp), the lantern will
automatically turn the fluorescent
lamp off and switch to the LED
light if the battery voltage falls
below a certain level. (The LAMP/
LED selector will remain in the
“LAMP” position.) This behavior is
a sign that the battery pack needs
to be recharged. (LN and R type
battery packs provide enough
power for about 60 minutes of LED
operation before the lantern turns off
automatically.)
• The LED operating time varies with
the amount of charge remaining in
the battery pack and other conditions.
When using the LED light
2) Set the LAMP/LED selector to
“LED”.
Getting the most out of your
lantern
Using the handle and hook
• In locations where there is nowhere
to sit the lantern…
When working on a power dis-
tribution panel
• Be careful to secure the lantern so
that it won’t fall.
Using the lantern in a hanging
position
Adjusting the handle angle
• The angle of the handle can be
adjusted to any of 8 positions at an
interval of about 45°.
LAMP LED
01-33_EY3741_EU.indd 601-33_EY3741_EU.indd 6 2010/01/21 18:25:192010/01/21 18:25:19
