Programming the Home Theater Remote
The remote control can be set to control other manufacturers components, by utilizing the MODE SELECTION
BUTTONS for CABLE, DSS, VCR, RCVR (a Receiver or Amplifier), CD, LD, and AUX (for Cassette Deck, Second VCR
or a DVD.)
Code Known
Use the following procedure for setting up the
remote control using the numerical buttons
when the component’s remote code is known.
n~l Determine the brand of the component.
[2l Identify the code{s) associated with the
brand from the infrared code index {see
following pages). Record all possible
codes.
3] Confirm that the component is plugged
in and'operating properly, then turn it
OFF.
m
Code From
Index Sheet
Press and hold theff^ button, then
the button so that both are
pressed at the same time for at least]
■srsecondi; Then let go of the buttons.
^ Press the appropriate Mode button
for the component.
^ Enter the 3-digit code, by using the
Remote Control Keypad “0”
through ”9” buttons.
[71 Press the button to test the remote. If
the correct code is setup for the
component (in step [B]), the component
will turn on.
Code Unknown
Use the following procedure for setting up the
remote control when the component’s remote
access code is not known. This procedure
uses the ’’sequence method”.
ID Confirm that the component is plugged
in and operating properly, then turn it
OFF.
Press and hold the button,
then the button so that both
are pressed at the same time for at
leasOIsecp Then let go of the
buttons.
EUR511050
m Press the appropriate Mode button
for the device.
^ Press the button to step
over to the next code.
Press the button to test the
remote. If the correct code is
sent, the component will turn on.
D Once the correct code Is found,
press the button
to store the code.
Repeat from step |H| above until the
proper component code is found. It
may take several attempts before
the correct code is found.
NOTE: Some brands have multiple codes.
Repeat the procedure using another
listed code until the component
responds correctly.
NOTE: If an incorrect code is entered, or
when the operation is not
completed within 30 seconds, the
settings will not change.
Infrared Remote Codes for Specific Components
l We/jE?/iu^W/h^ Write d
:h will serve as a hai
>de numbers for your components in
idy referenced nieed to
i^the^space provided below. This ^
reprogram your renipB control.
CABLE
Cable TV Converter Box
i
_____
VCR
Video Cassette Recorder
CD
Compact Disc Player
DSS
Digital Satellite System
RCVR
Receiver or Amplifier
LD
Laser Disc Player
Other Component
Other Component
Other Component
□
I Other Component
II Other Component
1 Other Component j
-26-
