104 Chapter 6 Maintenance
Lubricate the Stitch Head
Before You Begin
[58]
Apply Grease to the Driver Bar
[59]
Step Action Information
1. Trim the first part from the
nozzle.
figure 60 on page 102
2. Remove the cap from the tube
of grease.
3. Fit the nozzle to the tube of
grease.
4. On the user interface, touch
ADVANCED > STITCHER
UP > STITCHER UP
The folder cover must be
closed. This action moves the
stitch head to the correct
position for lubrication.
5. Lift the Booklet maker main
deck
See Lift the Booklet maker
Main Deck on page 41
Step Action Information
1 Use the supplied air duster to
remove dust from the stitch
head.
2 Remove the wire-holder from
the stitch head.
Move the wire-holder retaining spring
to the right. Then remove the
wire-holder (see Introduction on
page 102)
