DEPLAY
-T
~
~S
-T~M
This can be caused by
either of
E5
these reasons:
Not enough water is entering the
Urdatch
the door. If there is no water in the bottom of the
dishwasher.
dishwasher, check the
wter
supply to the dishwasher.
●
Is the
dishwasher water supply
tumd
on?
~dve
usually located under the sink.)
. Is the household
wter
supply turned on?
Q
If you use well or cistern water, is the supply adquate?
If the water supply is
adquate, try the cycle again. If
[5
repeats,
crdl
for service.
The drain pump could be
Udatch the door. If there is standing water in the bottom of
temporarily blocked (usually
the dishwasher,
relatch
the door, touch
“START;’
then
caused by food particles such
immediately touch
“CLEAWRESET”
to start the pump.
as cereal).
If
ES
continues to appear, you may need
b
do this
seved
times to breakup the blockage.
I-7
The temperature sensor in the
The temperature sensor
n~s
to be replaced.
Cdl
for
L/
dishwasher is not functioning
service.
properly. Dishwasher may
N~E:
continue to be used, but it will
You may continue to use your dishwasher. For best results
not heat water automatically.
adjust your household water heater thermostat to
140W.
L
or
Before you
dl
for
setice
●
Try the cycle again to see if
tie
Code
reappears. The dishwasher
may correct itself.
●
Electronic controls can be
affected by outside interference.
s
Sometimes shutting off the power
to the dishwasher (at the fuse or
circuit breaker) will correct the
problem.
. Restore power after about five
seconds and try the cycle again.
. Check the guide above for things
you can do to correct the problem.
9
