Installation Instructions TS318SU/TS318TU/TS325TU
17
Cable Management
1. Make all cable connections to display.
2. Open cable management covers on upper and lower swing
arms by unhinging center tabs and lifting covers to the open
position. (See Figure 27)
Figure 27
3. Route cables on top of upper arm. (See Figure 28)
4. (Optional) Use cable ties (not included) to secure cables to
upper arms by threading ties around cable and through
cable tie holes on arms. (See Figure 28)
5. Close upper cable management cover. (See Figure 28)
6. Route cables under lower portion of swing arm. (See
Figure 28)
7. (Optional) Use cable ties (not included) to secure cables to
lower arms by threading ties around cable and through
cable tie holes on arms. (See Figure 28)
8. Close lower cable management cover. (See Figure 28)
Figure 28
Creating Space
In order to create more space between display and wall,
spacers may be added.
1. Extend swing arms in order to gain access to the center
support.
2. Remove flat hex-head screw holding latch to center
support. (See Figure 29)
3. Place latch spacer (Z) behind latch and line with holes on
center support. (See Figure 29)
4. Install #10-24 x 1 1/4" flat hex-head screw (V) through latch
and latch spacer and into holes on center support. (See
Figure 29)
Figure 29
5. Remove 1/2" knob assembly installed on center support.
(See Figure 29)
6. Replace 1/2" knob assembly with 1" knob assembly (Y).
(See Figure 29)
2
2
3
4
cable ties
(not included)
2
8
cable (typical)
(Z)
remove and replace
with (Y)
3
2
4
5
6
remove and replace
with (V)
