Installation Instructions TS318SU/TS318TU/TS325TU
11
15. Loosely install two 5/16 x 2 1/2" flange head lag screws (F)
through lower wall rail on main assembly and into concrete
anchors. (See Figure 10)
16. Place two installation spacers over two flange head lag
screws. (See Figure 10)
17. Tighten two screws (F) to secure main assembly (M) to wall.
(See Figure 10)
Figure 10
WARNING: DO NOT REMOVE SPACER AS SHOWN
BELOW PRIOR TO INSTALLING THE LOWER TWO LAG
SCREWS OR THE MOUNT WILL FALL OFF THE WALL
WHEN THE SPACER IS REMOVED!
18. Loosen two flat head cap screws on upper carriage rail in
order to loosen white spacer. (See Figure 11)
19. Remove white spacer from mount. (See Figure 11)
20. Tighten flat head cap screws. (See Figure 11)
21. Proceed ahead to Interface Installation section.
Figure 11
Install TS318SU (Single Stud) to Wall
Install Wall Plate to Wall - Wood Studs
WARNING: Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component. The wall to which the mount is being attached
may have a maximum drywall thickness of 5/8" (1.6cm).
1. Determine mounting location.
2. Measure 6 1/8" above desired center line and mark a hole
at desired mounting location on the center of wood stud.
(See Figure 12)
NOTE: Hold mount up to wall at desired mounting location if
unsure about where the center line will be. The center
line of the mount will coincide with the center line of the
display. (See Figure 12)
IMPORTANT ! : Use a level to make sure main assembly
(M) is level when mounted to the wall!
3. Drill one 13/64" hole at location marked in Step 2. Hole
should be 2" in depth. (See Figure 12)
Figure 12
(F) x 2
(H) x 2
15
17
16
18
20
(N)
(M)
19
3
wood stud
6 1/8"
