P/N: 4LGE020-010 v3.1, 2012-03-12
© 2012 Lysholm
All Rights Reserved, Intl. Copr. Secured
40
F. Locate the 12-gage ground strap with two (2)
eyelets attached and cut one (1) end off.
Then connect a female spade connector as
shown. See fig 5D.
G. Replace the 16-gage ground wire from the
#86 pin position of the supplied relay assem-
bly with the modified 12-gage supplied wire.
H. Locate the 10-gage fuse holder assembly
and cut the wire in the middle as shown.
Attach a ring terminal to one end and a
female spade connector on the opposite end.
See fig 5E.
I. Replace the 12-gage short red wire from the
#30 pin position of the supplied relay assem-
bly with the modified 10-gage fuse assembly.
See fig 5F.
J. Install 20 amp fuse in fuse holder.
Fig 5E
Fig 5F
Fig 5D
