Closing the Cover
1. Release both the retention straps located on the
top of the cover behind the cab and press into the
stored position.
2. Unfold the tonneau cover to the closed position.
3. Lower the rear set of clamp assemblies from
the stored position.
4. Tilt the clamp assembly so that the locator is in the
slot, pull down on the assembly, and slide the clamp
under the edge of the inner lip on the bed rail.
5. Pull the handle toward the rear of the truck to
engage the clamp. Make sure the locator is secured
into the slot (A). If unable to completely engage
clamp, see the tightening and loosening procedures
later in this section.
6. The clamp should be securely engaged. Shake
the handle assembly to make sure the handle
does not move.
7. Repeat the clamp attachment steps 3 through 6 for
the opposite side.
8. Close the endgate.
2-4
