
Other Important Information
10
4-10
Important
17
Close the upper cover.
18
Tape each printer cover in the reverse order of tape removal during
setup.
(Æ P. 1-1 6)
19
If the output stacker or optional media take-up unit is installed, follow
the setup procedure in reverse order to remove it.
(Æ P.1-14 or Media Take-up Unit Setup Guide)
20
If the stand is set up, follow the stand setup procedure in reverse
order to remove it.
(Æ P.1-10)
21
If the stand is set up, follow the stand assembly procedure in reverse
order to disassemble it.
(Æ P.1-6)
22
Re-attach the shipping material to the roll holder and the printer unit,
then store them in the original boxes.
This completes preparing the printer for moving.
z After the printer reaches its destination, follow the procedures in Chapter 1
“Setting Up the Printer” to set up the printer again at the new site.