USING THE DETERGENT
20
30
A
B
C
CAUTION!
Use only detergents for dish-
washers.
1. Press the release button (B) to
open the lid (C).
2. Put the detergent in the compart-
ment (A) .
3. If the programme has a prewash
phase, put a small quantity of de-
tergent on the inner part of the ap-
pliance door.
4. If you use detergent tablets, put
the tablet in the compartment (A).
5. Close the lid. Make sure that the
release button locks into position.
Do not use more than the cor-
rect quantity of detergent. Refer
to the instructions on the deter-
gent packaging.
Detergent tablets do not fully
dissolve with short programmes
and detergent residues can stay
on the dishes.
We recommend that you use
detergent tablets with long pro-
grammes.
SETTING AND STARTING A
PROGRAMME
Setting mode
The appliance must be in setting mode
to accept some operations.
The appliance is in setting mode when,
after the activation:
• All the phase indicators come on.
• The time of the last set programme
flashes in the display.
If the control panel shows other condi-
tions, press and hold Multitab and De-
lay at the same time until the appliance
is in setting mode.
Starting a programme without
delay start
1. Open the water tap.
2. Press the on/off button to activate
the appliance.
3. Close the appliance door.
4. Make sure that the appliance is in
setting mode.
5. Turn the programme knob until the
marker on the knob is aligned with
the programme you want to set.
• The programme duration flashes
in the display.
• The phase indicators of the set
programme come on.
6. Press Start. The programme starts.
• Only the indicator of the phase in
operation stays on.
• The display shows the pro-
gramme duration that decreases
with steps of 1 minute.
14
