4 DE5450P PowerMax Programming Guide
Before anything else, gather up all keyfob units you intend
to enroll, and make sure they all have batteries installed.
Keyfob transmitter enrolling involves the following steps:
A. Perform Steps A through C in Para. 3.2 above, until the
display reads:
E N R O L L W L D E V I C E
B. Click <NEXT>. The display will read:
E N R O L L K E Y F O B
C. Click <OK>. The display will read:
K e y f o b N o : _
D. Suppose that the Keyfob you are about to enroll is to be
designated as Keyfob No. 5. Assuming that memory
location No. 5 is free - no keyfob has yet been enrolled
to it - click the <5> key. The display will change to:
K e y f o b N o : 5
The clear space at the far right tells you that the
memory location is free.
E. Click <OK>. The display will prompt you to initiate a
transmission from the chosen keyfob:
T R A N S M I T N O W
F. Initiate a transmission from the chosen keyfob by
pressing any one of its pushbuttons. In response, the
“Happy Tune” (- - - –––) will sound and the display will
change to:
K e y f o b N o : 5
A dark box will appear at the far right, indicating that the
chosen Keyfob has been enrolled as Keyfob No. 5.
Note: If the same keyfob is already enrolled elsewhere,
the “Happy Tune” will sound twice in succession.
G. From this point on, you may continue in several
different directions:
• If you wish to enroll another keyfob, select
the desired number by:
-
Clicking <NEXT> to go up (6
7
- Clicking
<BACK> to go down (4
3
2.....)
-
Clicking <HOME>
<keyfob #>.
After that, proceed as in the example above.
• To delete keyfob IDs, refer to Para. 3.4.
• To return to the main menu, click
<AWAY>. This will bring back the display:
< O K > T O E X I T
You may now review and select any other
mode on the installer’s menu (by clicking
<NEXT> or <BACK>).
3.4 Deleting Device and Keyfob IDs
Occupied zones or keyfob memory locations must be
cleared (enrolled ID must be deleted) before enrolling a
new ID. To delete an existing ID, proceed as follows:
A. Select the desired zone or memory location. If, for
example you selected Zone No. 15, or keyfob No. 8,
the display will read:
Z o n e N o . 1 5
or, in the other case:
K e y f o b N o . 8
B. Click <OK>. The display will change to:
< O F F > t o d e l e t e
C. Click <OFF>. The display will change to:
Z o n e N o . 1 5
or, in the other case:
K e y f o b N o . 8
Note that the dark box at the far right has disappeared.
It is now possible to enroll a new ID. It is also possible
to leave the cleared zone or memory location free, and
return to the main menu.
