Installation and Owner’s Manual 11
- Turn out and save the lower hinge pin [17].
- Open the lower door a small amount and pull the bottom of
the lower door away from the lower hinge of the refrigerator.
- Pull the lower door down off of the center hinge pin.
NOTE: Make sure that the plastic bushings [18] remain in the
door hinges.
2. Change the position of the cabinet hinges (See Art01657):
- Remove the screws from the upper cabinet hinge [19].
- Put this hinge on the other side of the refrigerator cabinet as
the lower cabinet hinge.
- Attach the hinge with the screws.
- Do not fully tighten the screws at this time.
- Remove the screws from the lower cabinet hinge [20].
- Put this hinge on the other side of the refrigerator cabinet as
the upper cabinet hinge.
- Attach the hinge with the screws.
- Do not fully tighten the screws at this time.
- Remove the three screws from the center cabinet hinge
[21].
- Remove the center cabinet hinge.
- Turn the screws back into the original holes and tighten the
screws.
- Remove the three screws on the opposite side of the
refrigerator cabinet.
- Reverse the center cabinet hinge and put it on the opposite
side of the refrigerator cabinet.
- Attach the hinge with the screws.
- Do not fully tighten the screws at this time.
- Turn the center hinge pin [16] out of bottom of the center
cabinet hinge.
- Reverse the center hinge pin and turn it down into the top of
the center cabinet hinge.
3. Change the position of the strike plate and the strike plate
cover for both doors (See Art01655):
- Remove the screws that attach the strike plates (with hole)
[5] and the strike plate covers (without hole) [6].
- Reverse the strike plates and the strike plate covers and
put each one on the other side of the refrigerator cabinet.
- Attach the strike plates and strike plate covers with the
screws.
4. Change the position of the door hinges and handle of both
doors (See Art00985 and Art01666):
- Remove and save the screws [1] that attach the door handle
[2] to each door.
- Remove the door handle from each door.
- Pull the panel retainers off each door.
- Reverse the panel retainers [3] and push onto opposite
side of each door.
- Reverse the door handle and put on the other side of each
door.
- Attach each door handle with the screws.
- Remove and save the plastic cap [ 22] that is opposite the
upper hinge of each door.
- Remove the screw [9] from each door hinge [11].
- Remove each upper door hinge.
- Reverse the hinge and put on the opposite side of each
door as the lower door hinge.
- Remove each lower door hinge.
- Reverse the hinge and put on the opposite side of each
door as the upper door hinge.
- Attach the hinges with the screws that were removed from
the other side of each door.
NOTE: You may need to pierce a hole in the door gasket
allow the screw to engage to door hinge.
- Put the plastic cap in the hole that is opposite the upper
hinge of each door.
5. Install the lower door:
- Make sure a hinge bushing is in the top of the upper door
hinge.
- Push the upper door hinge up onto the center hinge pin.
