ENGLISH
28
ADJUSTING TRANSMITTER AUDIO GAIN LEVEL (FIGURE 47)
The transmitter audio gain level has been factory pre-set to provide satisfactory
output in most applications. However, for loud singers or high-output musical instru-
ments, the preset level may be too high, as indicated by constant glow of the red au-
dio level LED. Soft-spoken talkers or singers may find that the factory setting is too
low, as indicated by the failure of the amber audio level LED to glow at all.
To adjust audio gain, open the battery compartment and locate the transmitter au-
dio gain control. Use the supplied screwdriver to make adjustments.
FIGURE 47
INCREASE
GAIN
DECREASE
GAIN
INCREASE
GAIN
DECREASE
GAIN
S For high sound pressure level applications, such as loud singing or playing,
decrease audio gain level by rotating the gain control counterclockwise
(while the microphone is in use) until the red audio level LEDs on the receiv-
er flickers during the loudest sounds.
S For low sound pressure level applications, such as soft singing or playing,
increase audio gain level by rotating the gain control clockwise until the red
audio level LEDs on the receiver flickers during the loudest sounds.
NOTE: For guitar applications, the minimum setting (full counterclockwise) is rec-
ommended.
If using the Shure WH10TQG headset, rotate the gain control to the full clockwise
position. Then, if necessary, rotate it back slightly.
