5
Connecting to an aerial or cable television network
To view television channels correctly, a signal must be received by the set from an outdoor aerial.
1. Connect the aerial to the coaxial socket on the rear of the television.
2. Insert the plug into the power supply.
3. Switch ON using the button on the front panel. The power indicator will light up.
NOTE:
· The indicator light on the front panel TV lights in standby mode.
· When you switch on the television the indicator light is dies out.
· The power turns off approximately 5 minutes after a TV station has stopped broadcasting.
Connecting the equipment to the input/outputs
Location the Audio/Video connector is depending on the television model.
· The Audio/Video connector on the side of the TV is used for AV equipment.
· With TV/AV button you can select video and audio inputs.
· With TV/AV button you can select the signal from other equipment such as VCR or CD video player.
Inserting the batteries in the remote control
1. Remove the battery cover.
2. Insert the 2 UM4-AAA 1.5V batteries making sure the polarity (+ or -) of the batteries matches the polarity marks inside the unit.
3. Replace the battery cover.
Replace with new batteries when the TV set begins to show the following symptoms:
Operation is unsteady or erratic. Sometimes the TV set does not function with Remote Control Unit.
Remark:
1) Alkaline Batteries Recommended
2) Remove batteries when they are exhausted or if the remote control is not to be used for a long time.
