Installing a V.34 Console Modem Module in a BayStack ARN Router
8
114313-B Rev 00
Closing the ARN
To replace the ARN enclosure:
1.
Remove the antistatic wrist strap.
2.
Facing the back panel, align the enclosure top around the base module
component tray and slide the enclosure in until it meets the front panel.
If you meet resistance, lift up slightly on the enclosure, and center the
component tray between the enclosure edges.
3.
Secure the two captive screws that hold the cover to the component tray
(Figure 9)
.
Figure 9. Securing the Captive Screws
4.
Reconnect any cabling you removed from the front and back panels.
5.
Plug in the power cord and, if applicable, the redundant power supply
cable (refer to Figure 1
).
6.
Attach the label that came in the upgrade kit to the ARN back panel.
ARN0049A
U
L
U
L
100-240~
1.2A
50-60Hz
Console Modem
Redundant Power
