2 Part Number 308602-14.20 Rev 00
• Configure
ip
at the interface level with a specific IP address and subnet mask. For
example, enter either of these commands:
-- ip address 192.184.68.24 mask 255.0.0.0
-- ip 192.184.68.24/255.0.0.0
• Enter show commands (for statistical information) and help commands at any level of the
object hierarchy. You do not need to change to another mode to use these commands.
Figure 1. Hierarchy of BCC Objects
Sample Session
To create the sample configuration shown in Figure 1 on a BN router with an Ethernet link module
in slot 2, enter the following BCC commands. Notice how each BCC prompt contains the BCC
identifier of the object just configured.
Command Comment
box# ethernet slot 2 connector 1 Configures ethernet 2/1 using a fully specified
interface location.
ethernet/2/1# ip 11.23.13.14/8 Configures ip/11.23.13.14/255.0.0.0 using a
decimal mask value. The BCC automatically
configures the global ip object when you configure
the first ip interface on the box.
ip/11.23.13.14/255.0.0.0# rip Configures RIP on ip/11.23.13.14. No parameter
values are required.
rip/11.23.13.14# back Moves back one level closer to box or root level.
ip/11.23.13.14/255.0.0.0# back 2 Moves back two levels to box level.
box# eth 2/2 Configures ethernet 2/2 using abbreviated syntax.
(Slashes between required parameter values
only.)
(continued)
box
ethernet slot 2 connector 1
ethernet slot 2 connector 2
ip address 11.23.13.14 mask 255.0.0.0
rip
ip address 11.23.13.15 mask 255.0.0.0
rip
BCC0037A
ip
