ATL User Guide
AM2 G.SHDSL Modem
14
5 INSTALLATION
This chapter describes the basic steps that are required to set up a system using the AM2. It is recommended
that if two desktop units are to be connected they should be tested back to back to check for correct
operation before deployment.
5.1 LED POWER ON SEQUENCE
During the power up/self test sequence the WAN LNK and ACT LEDs are both on continuously and the ALM
led flashes for around 14 seconds. The WAN LNK and ACT LEDs will then go out and the four LAN LEDs will
flash once.
5.2 DEFAULT SETTINGS
IP Address 10.254.254.253
Mask 255.255.0.0
Interface Link IPoA
Data Rate 0 (rate adaptive)
Annex Type Annex_B
Host Name SOHO
Network Type Global
VPI 0
VCI 32
ENCAP LLC
QoS UBR
PCR 4800
Rip Mode Disabled
VLAN Disabled
Gateway IP Address 192.168.0.254
