Getting Started
BreezeCONFIG for BreezeACCESS VL and BreezeACCES 4900 User Manual
4
Toolbar: The toolbar is comprised of the following four buttons:
Local Network Autodiscovery: Automatically discovers
stations connected to the local (Ethernet) network.
Locate Device: Locates an individual unit by its IP address.
Set IP: Sets a unit’s IP address based on its MAC address.
HTTP Browse: Supports easy access to management of devices
with a built-in web interface such as Gateways and WI2 Access
Points.
For more information, refer to section
1.3.
Device List: The Device List displays the units that can currently be
managed by the BreezeCONFIG utility.
Each unit is displayed according to the unit's IP address and unit type as well
as the unit location, which is defined in the Unit Status & Info tab.
The Device List can be sorted by clicking one of the column headers, for
example Type. The list is sorted in ascending order according to the selected
column. Click the column header again to sort in descending order.
Units are selected from this list for configuration. To select a unit, double-
click the relevant row in the Device List. The entry is highlighted in black
when it is selected. Information is then gathered from the device and
displayed in the selected tab area. Once all information is loaded, the entry is
highlighted in blue; therefore, wait until the entry highlighting turns from
black to blue before reviewing or modifying the configuration.
In Multiple Configuration mode you can use the standard Windows Shift or
Ctrl key commands to select multiple units.
SNMP Community: The SNMP Community area enables you to enter an
SNMP community string, which is used by BreezeCONFIG when sending an
SNMP request to the selected device(s).
Unit information can be viewed only when using its Read or Read/Write
community string. Otherwise the unit does not appear in the Device List.
Configurable parameters can be changed only when using the Read/Write
community string.
