A. Insert a power cord into the main Inlet.
B. Turn the power switch ON
How to set Flash Power Intensity
1. By increasing or decreasing 0.1 F-stop.
- Turn the digital encoder volume (①) to the right, then the power intensity is increased.
- Turn the digital encoder volume (①) to the left, then the power intensity is decreased.
2. The maximum power output mode.
- Press the encoder (①) only once.
3. The minimum power output mode.
- Press the encoder (①) only twice.
4. The restoration mode. (It is restored to the last set-up power intensity value by a user)
- Press the encoder (①) three times.
-
How to control Modeling light
1. By increasing or decreasing 0.1 F-stop
- Turn the digital encoder volume (②) to the right then the brightness of the Modeling Light
is increased.
- Turn the digital encoder volume (②) to the left then the brightness of the Modeling Light
is decreased.
2. The maximum power output mode.
- Press the Encoder (②) only once.
3. The minimum power output mode.
- Press the Encoder (②) only twice.
4. Turn off the Modeling Light
- Press the Encoder (②) three times.
5. The restoration mode. (It is restored to the last set-up power intensity value by a user)
- Press the Encoder (②) four times.
