Installation Instructions
RG6 LED Signals – 12’’ (300mm) – Railway Grade Crossing
Operating Specifications:
8V to 16V AC
8V to 20V DC
Nominal Power Consumption:
Always use a sun shielding apparatus such as a visor or hood over the signals.
Do not attempt to open the LED module. No assembly is required.
Testing:
When testing the lamp before installation, first check the electrical characteristics on the label on the back of the lamp
(see box “B” below) to avoid damaging the lamp.
Installation Steps:
NOTE: Failure to properly follow these instructions may cause signal to malfunction.
1. Remove the incandescent bulb, reflector and lens assembly from the housing.
2. Feed wires of the LED signal module through the conduit in the housing.
3. Insert the LED signal into the lens slot and rotate it until the arrow on the back of the module (A) is aligned with the
top of the housing.
4. Lock the LED signal module in place by tightening metal tabs over the rim of the module, or fastening a ring holder
over the module, as applicable.
5. Connect the wires to the AAR terminals.
…Page 2
BEFORE YOU BEGIN
Read these instructions completely and carefully.
Prepare Electrical Wiring
Electrical Requirements
Do not use in wet locations
Follow all National Electric Codes
(NEC) and local codes.
WARNING / AVERTISSEMENT
Risk of Electric Shock. Disconnect Before Servicing or installing product.
Risque de choc électrique. Couper l’alimentation avant le dépannage ou avant
l’installation du produit.
