Chapter 5 Broadband
VMG8924-B10A and VMG8924-B30A Series User’s Guide
55
IPv6 Address Select Automatic if you want to have the Device use the IPv6 prefix from the connected
router’s Router Advertisement (RA) to generate an IPv6 address.
• Select Get IPv6 Address From DHCPv6 Server(IA_NA) if you want to obtain an IPv6
address from a DHCPv6 server. The IP address assigned by a DHCPv6 server has priority
over the IP address automatically generated by the Device using the IPv6 prefix from an
RA. This option is available only when you choose to get your IPv6 address
automatically.
• Select Prefix Delegation(IA_PD) to use DHCP PD (Prefix Delegation) which enables
the Device to pass the IPv6 prefix information to its LAN hosts. The hosts can then use
the prefix to generate their IPv6 addresses.
Select Static if you have a fixed IPv6 address assigned by your ISP.
Select None to not assign any IPv6 address to this WAN connection.
WAN IPv6
Address
Enter the IPv6 address assigned by your ISP.
Prefix
Length
Enter the address prefix length to specify how many most significant bits in an IPv6 address
compose the network address.
Next Hop Enter the IP address of the next-hop gateway. The gateway is a router or switch on the
same segment as your Device's interface(s). The gateway helps forward packets to their
destinations.
IPv6 Routing Feature (This is available only when you select IPv6/IPv4 DualStack or IPv6 Only in the
IPv6/IPv4 Mode field. You can enable IPv6 routing features in the following section.)
MLD Proxy
Enable
Select this checkbox to have the Device act as an MLD proxy on this connection. This allows
the Device to get subscription information and maintain a joined member list for each
multicast group. It can reduce multicast traffic significantly.
Apply as
Default
Gateway
Select this option to have the Device use the WAN interface of this connection as the system
default gateway.
IPv6 DNS
Server
Configure the IPv6 DNS server in the following section.
IPv6 DNS Select Dynamic to have the Device get the IPv6 DNS server addresses from the ISP
automatically.
Select Static to have the Device use the IPv6 DNS server addresses you configure
manually.
IPv6 DNS
Server 1
Enter the first IPv6 DNS server address assigned by the ISP.
IPv6 DNS
Server 2
Enter the second IPv6 DNS server address assigned by the ISP.
VLAN (These fields appear when the Type is set to ADSL/VDSL over PTM.)
Active Select this option to add the VLAN tag (specified below) to the outgoing traffic through this
connection.
802.1p IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a MAC-layer frame
that contains bits to define class of service.
Select the IEEE 802.1p priority level (from 0 to 7) to add to traffic through this connection.
The greater the number, the higher the priority level.
802.1q Type the VLAN ID number (from 1 to 4094) for traffic through this connection.
QoS
Rate Limit Enter the rate limit for the connection. This is the maximum transmission rate allowed for
traffic on this connection.
WAN Outgoing
Default Tag
Select Enable and enter a DSCP (DiffServ Code Point) value to have the Device add it in the
packets sent by this WAN interface.
Table 7 Network Setting > Broadband > Add New WAN Interface/Edit (Routing Mode) (continued)
LABEL DESCRIPTION
