Chapter 1 Introducing the Device
VMG8924-B10A and VMG8924-B30A Series User’s Guide
24
To activate WPS:
1 Make sure the PWR/SYS LED is on and not blinking.
2 Press the WPS button for five seconds and release it.
3 Press the WPS button on another WPS-enabled device within range of the Device. The WiFi 2.4G
LED flashes orange while the Device sets up a WPS connection with the other wireless device.
4 Once the connection is successfully made, the WiFi 2.4G LED shines green.
To turn off the wireless network, press the Wi-Fi button for one to five seconds. The WiFi 2.4G
LED turns off when the wireless network is off.
1.8 Wall-mounting Instructions
Do the following to hang your Device on a wall.
1 Locate a high position on a wall that is free of obstructions. Use a sturdy wall.
2 Hold the bracket against the wall and mark where to drill the holes.
3 Drill the two screw holes in the wall.
Be careful to avoid damaging pipes or cables located inside the wall
when drilling holes for the screws.
4 Align and insert the bracket to the wall-mounting notches on the rear panel of the Device.
