Connecting the Wave Server to your LAN 3-11
Chapter 3: Setting Up the Wave IP 500 Server
Wave Server Installation Guide
5. Connect the external power supply cable to the connector, and then connect the cable to
power.
6. Power on the Wave Server by toggling the rocker switch, and then press the red button on
the front of the Wave Server.
7. Observe the status LEDs on the front of the Wave Server chassis to ensure that the system
initialization completes successfully and that there are no component failures.
For complete details of the information provided by the status LEDs, see Appendix C,
“Integrated Services Card Status LEDs.”
Connecting the Wave Server to your LAN
This section describes how to connect the Wave Server to your LAN using a standard Ethernet
cable.
Note: The cabling for your LAN should be installed by a network cabling professional before
the arrival of the Wave Server.
To connect the Wave Server to your LAN:
1. Locate the 8-pin modular RJ-45 Ethernet port labeled ENET on the front of the ISC2.
2. Connect one end of a standard, straight-through Ethernet cable to the ENET port.
3. Connect the other end of the cable to your LAN’s hub or data switch.
Release 2.0 Service Pack 1
