1. When a probe reaches target temp (37°F)
an alarm will sound for 30-seconds. The
display the will continuously flash DONE.
2. Press the button alongside the probe
flashing DONE.
3. The print menu will appear. Press...
- RECORD to receive a paper printout.
4. Repeat for additional probes.
5. Press NONE when complete to select next
probe or return to Main Menu (after last
probe).
6. Properly sanitize probes prior to next use.
Ending The Cycle/Printing
5 TRAULSEN RBC50, RBC100 & RBC200 BLAST CHILLER TRAINING GUIDE
Printing
Paper
Cycle
Data
Printout
PRINT PROBE #1
RECORD
NONE
1. Remove the control cover or open printer access door on RBC50 (see figure 1).
2. Remove the paper spindle and discard the empty paper roll (see figure 2).
3. Open feed roller tension arm by gently pulling this down and forward (see figure 3).
4. Place a new paper roll onto the spindle and set this in the paper cradle. Note paper must be
loaded with thermal side facing up.
5. Feed paper up through the open feed roller tension arm (see figure 4).
6. Close feed roller tension arm and push paper through the slot in the control cover.
7. Replace control cover (close printer access door on RBC50).
NOTE:
Replacement paper should be ordered using your division’s normal supplies
replenishment procedures.
Changing The Printer Paper
fig. 1
fig. 2
fig. 3 fig. 4
Folding paper into a
point as shown here
facilitates loading.
