Connection
Select Operation on the Remote Controiler
1.
TV/AV
Push the “TV/AV” Button on the Remote Controller.
Then last selected AV mode will be displayed on the screen.
2.
AV SELECT
Select the “AV3” mode by pushing this button, you can sequentially
select three AV modes, as shown below.
3.
PLAY
Push the “PLAY” Button on the Connected Equipment.
o
Helpful Hint
SYSTEM
System Button
On the AV mode, if the clear picture cannot be obtained even when the
AV signal is received, push the System Button repeatedly until the
optimum image can be produced.
F=br operation details, refer to “System Select Operation” on page 49.
Note:
(1) When AV mode (AV1, AV2 and AV3) is selected and the selected AV mode has no AV signal, the
On-screen will be changed from Black out picture to Colour back picture.
(2) When the played back picture may be unstable, then by pushing “Play” Button you can obtain
the clear picture.
(3) When the S-Video cable is connected to S-Video Terminal, Input Terminal will be changed from
Video to S-Video Terminal.
(4) When the Monaural \^R is played back, Connect the Monaural Audio cable to the Audio “L”
(Left) Terminal.
31
