08/13 Rev. E 147774
CAUTION!
DO NOT SIT OR STAND ON TOP OF THESE CABINETS AND
DO NOT USE THE DRAWERS AS A STEP.
SERIOUS INJURIES CAN OCCUR.
Install casters per the following diagram.
Note: Install casters with brakes to the front of the cabinet.
MAINTENANCE
General Cleaning
Beginning with the initial installation, the interior surfaces of the cabinet should be
periodically cleaned with a solution of warm water and baking soda. This solution will
remove any odors from spillage that has occurred. The exterior of the cabinet should
also be cleaned frequently with a commercial stainless steel cleaner, glass cleaner or
mild soap solution. Do not use chlorinated cleaners on the stainless steel surfaces.
The door gaskets should be cleaned in place with a mild soap solution to extend their
life.
Condenser Coil Cleaning
Prior to cleaning the condenser coil disconnect the unit from power. Periodic cleaning
of the condenser coil will aid the heat transfer of the refrigeration system and increase
its efficiency. To accomplish this, remove the front grill from the cabinet. The
condenser coil is located behind the grill. Use a soft bristled brush to remove any dirt
particles that are on the fins of the condenser coil. Use a vacuum cleaner or
compressed air to remove the loosened particles. Replace the grill and reconnect the
unit to power. Failure to clean the condenser coil can lead to performance loss and
compressor failure. It is recommended a minimum of every three months.
