Produtos da Marca Netgear

Gather Configuration Information from

Your Internet Service Provider

Before installing the DG814 gateway, you should have active DSL service and an Internet account

with an Internet Service Provider (ISP).

For each computer that you want to connect to the gateway, you must have

• An available RJ-45 Ethernet port (or adapter) — either built-in or from a network

interface card (NIC) installed in the computer.

Note: If you have a built-in modem or a modem card, the telephone jack for the

modem looks very similar to an RJ-45 Ethernet port, but the RJ-45 port is larger.

• TCP/IP networking installed.

• Windows® computers: Client for Microsoft® Networks software installed.

Note: TCP/IP and Client for Microsoft Networks is installed on most Windows

computers. If you have viewed Web sites with a browser, you are ready to go.

Please see the

Reference Manual on the CD if you need help installing either on a

Windows computer.

• A Category 5 (Cat 5) Ethernet patch cable

Note: There is one cable in the box with the gateway.

Connection information

Later in the setup process you’ll use a Configuration Utility to configure the gateway to work

with your network and, at that time, you’ll need to know the type of account you have your

ISP and specific account information.

The next page includes blanks for you to fill in and refer to later.

Note: Your ISP should have provided you with a summary sheet of all the

information needed to connect your computer to the Internet. If you cannot locate

the information, you’ll have to contact your ISP.