Dil ID: 12
Dil Adı: portugal
Dil Kodu: pt9tayfun Produtos da Marca JL Audio
Dünyanın En Büyük
Elektronik Bilgi Kütüphanesi



D) Subwoofer Level Control Only:
Req uired: a source unit or processor with
one pair of stereo outputs and dedicated
subwoofer outputs.
Inp ut Connections: the stereo pair of source
unit outputs each split with a “Y-Adaptor”
allowing the left signal to be sent to the CH
1 (Left)and CH 3 (Left)” inputs and the
right signal to be sent to the CH 2 (Right)
and “CH 4 (Right) inputs of the G6600. The
source unit’s dedicated subwoofer outputs are
connected to the CH 5 (Left)and
CH 6 (Right)” inputs (select “Discreteon
the “Input Mode switch in the “Channel 5 &
6 Controls” section).
R e s u l t : in this mode, the user has the ability to
control the absolute level of the LF channels
relative to the HF channels.
E) Independent level control of all three
channel pairs:
R e q u i r e d : a source unit or processor with
two pairs of stereo outputs and dedicated
subwoofer outputs.
Inp ut Connections: one pair of stereo source
unit outputs is connected to the CH 1
(Left)” and “CH 2 (Right) inputs, the
second pair of stereo source unit outputs is
connected to the CH 3 (Left)and CH
4 (Right) inputs and the source unit’s
dedicated subwoofer output is connected
to the CH 5 (Left)and “CH 6 (Right)
inputs (select Discrete” on the “Input
Mode” switch in the Channel 5 & 6
Controls” section).
R e s u l t : in this mode, the user has the ability to
control the absolute level of the LF channels as
well as both pairs of HF channels.
When using a source units dedicated
subwoofer output, set the “Input Sens.” of any
channels receiving input from the subwoofer
output with the source unit’s subwoofer level
control set at 3/4 of full output. See Appendix A
(page 14) for details.
Crossover Setup for Bi-Amplified System
with one G6600:
Once the input sections have been configured
appropriately, go to the “Channel 5 & 6
Controls”. Select LP(low-pass) on the Filter
Mode” switch and an appropriate Filter Freq.
(80 Hz is a good starting point).
Next, turn your attention to the Channel 1 &
2 Controls” and Channel 3 & 4 Controls” and
select HP(high-pass) on the Filter Mode
switches and an appropriate Filter Freq.” (again,
80 Hz is a good starting point).
After proper adjustment of the Input Sens.
controls for all three channel pairs using the
method shown in Appendix A (page 14), you can
fine tune filter frequencies and attenuate any pair
of channels to achieve proper balance. For precise
filter frequency information refer to Appendix B
(page 15).
12 JL AUDIO G6600 JL AUDIO G6600 13