f. Search: press CH +/- to choose this item, then press VOL +/- to proceed to
search channels by hand.
g. Auto-Search: the original set is auto search, press VOL +/- to make it auto
search. It would search all the currently TV channels and store them.
Caution:
1. When performing manual search, press VOL +/- can reverse the searching
direction. Press MENU to stop manual search.
2. Use CH +/- to select channel number. If a channel is preset, the channel number
will become red.
Note:
1. Hue setting applies to NTSC input only.
2. Volume can simply be adjusted by pressing VOL +/-.
3. OSD menu will automatically exit in 10 seconds.
Using the Earphones
Please insert the provided earphones to the earphone jack on the unit in order to enjoy
programs without disturbing other people. The sound quality is not guaranteed if you
use earphones other than the provided.
Using an outdoor antenna
If the wireless TV signal is too weak for the built-in antenna, you may use an outdoor
antenna. You can connect the outdoor antenna and the TV using an antenna connector
through the antenna jack of the LCD TV.
Rear vision
a. AV cable connection
1. Slug pin
2. RCA (red) Audio input
3. RCA (yellow) Video 1 input
4. RCA (white) Video 2 input (can be used for connecting the rearview
camera)
b. Rear vision
Whenever necessary, you may watch the rearview by pressing the TV/AV key to
switch to AV2, if AV2 is connected to the rearview camera.
c. Auto rear vision
Connect the slug pin of the AV cable to the reverse gear wire of your car. The
TV will automatically switch to AV2 while backing the car.
