Menu item Sub-menu item Sub-menu item Values and Description
Default IP Specify the IP address to default to when the print server
is unable to obtain an IP address from the network during
a forced TCP/IP reconfiguration (for example, when
manually configured to use BootP or DHCP).
Auto IP: A link-local IP address 169.254.x.x is set.
Legacy: The address 192.0.0.192 is set, consistent with
older HP Jetdirect devices.
Primary DNS Specify the IP address (n.n.n.n) of a Primary DNS Server.
NOTE: This item appears only if Manual configuration is
a higher priority than DHCP in the Config. Precedence
table, configured through the embedded Web server.
Secondary DNS Specify the IP address (n.n.n.n) of a Secondary Domain
Name System (DNS) Server.
NOTE: This item will appear only if Manual
configuration is a higher priority than DHCP in the Config.
Precedence table, configured through the embedded
Web server.
IPV6 Settings Enable Use this item to enable or disable IPv6 operation on the
print server.
Off: IPv6 is disabled.
On (default): IPv6 is enabled.
Address Use this item to manually configure an IPv6 address.
Manual Settings: Use the Manual Settings menu to enable
and manually configure a TCP/ IPv6 address.
Enable: Select this item and choose On to enable manual
configuration, or Off to disable manual configuration.
Address: Use this item to type a 32 hexadecimal digit IPv6
node address that uses the colon hexadecimal syntax.
DHCPV6 Policy Router Specified: The stateful auto-configuration method
to be used by the print server is determined by a router.
The router specifies whether the print server obtains its
address, its configuration information, or both from a
DHCPv6 server.
Router Unavailable: If a router is not available, the print
server should attempt to obtain its stateful configuration
from a DHCPv6 server.
Always: Whether or not a router is available, the print
server always attempts to obtain its stateful
configuration from a DHCPv6 server.
Primary DNS Use this item to specify an IPv6 address for a primary DNS
server that the print server should use.
NOTE: This item will appear only if Manual
configuration is a higher priority than DHCP in the Config
Precedence table, configured through the embedded
Web server.
ENWW Advanced network configuration 31
