2. Prepare the card for installation.
See the documentation that shipped with the card for information on configuring the card, making internal connections, or otherwise customizing it for
your computer.
3. If you are installing a PCI Express card into the x16 card connector, position the card so the securing slot is aligned with the securing tab.
4. Place the card in the connector on the system board and press down firmly. Ensure that the card is fully seated in the connector.
5. Push the PCI support bracket down until it clicks into the filler brackets.
6. Pivot the expansion card retainer towards the alignment bar until it snaps into place.
7. Connect any cables that should be attached to the card.
See the documentation that shipped with the card for information about the card's cable connections.
8. Replace the computer cover (see Replacing the Computer Cover).
9. Reconnect the computer and devices to electrical outlets, and then turn them on.
10. To complete the installation, see Configuring Your Computer After Removing or Installing PCI and PCI Express Cards.
Configuring Your Computer After Removing or Installing PCI and PCI Express Cards
Back to Contents Page
CAUTION: Do not route card cables over or behind the cards. Cables routed over the cards can prevent the computer cover from closing properly
or cause damage to the equipment.
NOTE: For information on the location of external connectors, see the Setup Guide. For information on installing drivers and software for your card, see
the documentation that shipped with the card.
